9.0 Instructions
9.1 Carrying out instructions
To access the instructions, click on the “Instructions” tab at the bottom of the display.
All instructions created by the planner for a specific test are listed here.
Instructions can be given the following processing status by the tester:
- Gray tick: Instruction has not yet been executed.
- Green tick: Instruction has been carried out successfully.
- Red cross: Instruction has not been carried out successfully
Click either the green "Successful" Button or the red "Not successful" Button to signal if an instruction was able to be carried out.
If an instruction cannot be carried out successfully, the tester is asked to explain the reasons and circumstances for this.
His answer, as well as the processing status of the instruction, can be edited again at any time during an active test.
9.2 Status of Instructions
Within the list of instructions, the processing status of the instructions is shown using various icons on the right-hand edge of the display:
- Gray tick: Instruction has not yet been executed.
- Green tick: Instruction has been carried out successfully.
- Red cross: Instruction has not been carried out successfully
